Shower Timer

Shower Timer Programming Instructions

• To enter programming mode, disconnect the power for 30 seconds. After the initial installation it may be necessary to remove power at the fuse box.

• Within 2 minutes of re-connecting power to the timer, press the Start button and hold for 10 seconds. The buzzer will sound 2 beeps and the display will flash “P1”.

• Repeatedly press the button to cycle through the program options in accordance with the table shown below. When the desired shower setting is displayed, press and hold the button for approximately 3 seconds (holding for 10 secs will take you out of programming mode). To confirm your selection, the buzzer will beep when you release the button and the display will cease flashing.

• If you want to change the shower prevention time between showers, continue pressing the button to advance to the desired prevention time. Press and hold for approximately 3 seconds. (Buzzer will beep when you release the button)

• When in programming mode, the display will flash on all except the two currently selected options.

• Holding the button for 10 seconds will return the timer to Normal mode. Failure to press the button during any period of 30 seconds will also return the timer to Normal mode.

In the following table, the left hand column indicates the cycling sequence and the visual display. The other two columns interpret the display options into Shower time and Shower prevention time:

	DISPLAY	SHOWER	PREVENTION
	P1	1 min
	P2	2 mins
	P3	3 mins
	P4	4 mins
	P5	5 mins
	P6	6 mins
	P7	7 mins
	P8	8 mins
	P9	9 mins
	P10	10 mins
	P11	11 mins
	P12	12 mins
	00	No shower
	L0		No waiting
	15		15 seconds
	30		30 seconds
	L1		1 minute
	L2		2 minutes

NOTE: In a domestic situation the owner can choose to have the power supply manually switched on and off from within the bathroom. It could be associated with the exhaust fan (piggy back) and switched on and off with the fan.

In this case, the timer operates normally while the power is on but turning the switch off and on again resets the timer to Normal mode – ready to go again immediately.

Shower Timer product | Shower Timer support | Shower Timer the company Water Saving, Electricity Saving and Gas Saving Tips